The LPC2290 is based on a 16/32 bit ARM7TDMI-S™ CPU with real-time emulation and embedded trace support. For critical code size applications, the alternative 16-bit Thumb® Mode reduces code by more than 30 pct with minimal performance penalty. With its 144 pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, 2 advanced CAN channels, PWM channels and up to 9 external interrupt pins this microcontroller is particularly suitable for automotive and industrial control applications as well as medical systems and fault-tolerant maintenance buses. LPC2290 provides up to 76 GPIO depending on bus configuration. With a wide range of additional serial communications interfaces, it is also suited for communication gateways and protocol converters as well as many other general-purpose applications.
Features

• 16/32-bit ARM7TDMI-S microcontroller in a LQFP144 package.
• 16 kB on-chip Static RAM.
• Serial boot-loader using UART0 provides in-system download and programming capabilities.
• EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with the on-chip RealMonitor™ software as well as high speed real-time tracing of instruction execution.
• Two interconnected CAN interfaces with advanced acceptance filters. Additional serial interfaces include two UARTs (16C550), Fast I²C (400 kbits/s) and two SPIs.
• Eight channel 10-bit A/D converter with conversion time as low as 2.44 us.
• Two 32-bit timers (with 4 capture and 4 compare channels), PWM unit (6 outputs), Real Time Clock and Watchdog.
• Vectored Interrupt Controller with configurable priorities and vector addresses.
• Configurable external memory interface with up to four banks, each up to 16 Mb and 8/16/32 bit data width.
• Up to 76 general purpose I/O pins (5 V tolerant). Up to 9 edge/level sensitive external interrupt pins available.
• 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop with settling time of 100 us.
• On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.
• Two low power modes, Idle and Power-down.
• Processor wake-up from Power-down mode via external interrupt.
• Individual enable/disable of peripheral functions for power optimization.
• Dual power supply:
  • CPU operating voltage range of 1.65 V to 1.95 V (1.8 V +-0.15 V).
  • I/O power supply range of 3.0 V to 3.6 V (3.3 V +- 10 pct) with 5 V tolerant I/O pads.